- Reusable silicone faucet knockout that will create a 1-1/4" hole which will work with most standard faucets
- It will also create a 2-1/2" pocket that is 1" beneath the surface to fasten hardware in
- This will accept most faucets and spouts
- Must be used with 1/2" substrate and Z-Counterform standard 2-1/4" forms
- Please Note: Some of the newer faucets require larger than 1-3/8" hole. Please check you faucet.
Installation: Use a 2-5/8" hole saw. Push the knockout up through the hole from the underside of the cement board until the 3rd ring hits the bottom of the cement board. Check to make sure the top of the knockout is flush with the top of the forms. For most applications splitting the difference between the sink opening and the backwall will give you the most concrete possible around the faucet. If you have a deeper countertop or smaller sink, please check to make sure that the faucet is lined up properly over the sink.